PetrophysicsResistivity Logs
Oil Saturation from IE and CDN Resistivity Logs Formula
Oil Saturation from IE and CDN Resistivity Logs calculates oil saturation for resistivity logs workflows in petrophysics.
How engineers use this formula
Use this formula when the listed inputs (R_o, R_t) are known and the assumptions behind the cited resistivity logs relationship match the engineering case being checked.
Assumptions
- Input values are representative for the well, reservoir, fluid, or equipment case being evaluated.
- The declared units match the field-unit constants used in the formula.
- The cited formula applies to the selected petroleum engineering workflow.
Limitations
- The calculation does not replace a full engineering model or operating procedure.
- Accuracy depends on the source correlation, assumptions, input quality, and unit consistency.
Common mistakes
- Mixing unit systems without converting the inputs.
- Using default example values as field recommendations.
- Applying the formula outside the source assumptions.
Default example
Using the default inputs, S_o equals 0.5 fraction.
R_oohm m
5
R_tohm m
20
Inputs
R_o
ohm mHydrocarbon Formation Resistivity
R_t
ohm mRock Resistivity
Outputs
S_o
fraction
Oil Saturation
S_w
fraction
Water Saturation
R_o
ohm m
Hydrocarbon Formation Resistivity
R_t
ohm m
Rock Resistivity
Source and review
reviewedTheory, Measurement, and Interpretation of Well Logs, Bassiouni, Z. (1994)
Bassiouni, Z. 1994. Theory, Measurement, and Interpretation of Well Logs. SPE Textbook Series Vol. 4, Chapter 11, Page 213.
Source